Jump to content
  • Welcome Guest!

    Please register or sign in to have the complete Shroomology community experience! Become a member today, post topics, get your own profile, personal messenger and more!

Greg4545

what is this, and can I eat it?

Recommended Posts

Greg4545

20190311_185547.jpg

Share this post


Link to post
Share on other sites
Mush Zombie

no ID requests per website rules, and mushroom hunting forum rules. DO NOT eat any mushroom you find that you cannot positively identify yourself.

Share this post


Link to post
Share on other sites
Greg4545

I came across this in northern California (Morgan Hill) today.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Recently Browsing

    No registered users viewing this page.

  • Topics

  • Posts

    • Newgrower222
      Thanks for the info. So I went on and tried to create 2 jars of LC. One with maple syrup and one with honey. I did them just like the instructions on this forum and was as careful as possible not to get contamination like sterilising the needle after each injection and so on. The jars you see in the picture are for more than 20 days ago if you look really close there are some tiny strings are visible in there but I'm not sure if it's mycelium. And the two jars of grains are a mix of grains and wild bird seed. It's been 5 days since I injected them with spore syringe but there is no sign of mycelium, not even a green mold of contamination. The syringe is b+ from Avalon . I'm thinking maybe I've got pure water inside a syringe. Give me some hope guys it's really frostrating to see the only hope of fun I had is going nowhere.😑😑😑 I don't even care about taking shrooms I just want to see mycelium grow... Btw I've been keeping the jars in a room temperature in the dark of course.
    • DonkeyHote
      Now that you have pins I would cut back on the fanning.  When my mush stays small, it's usually a lack of FAE. My setup is ultra low tek. I start sgfc with the holes taped up on sides and top. After I get pins I untape some/most of the holes to adjust FAE. It's kind of bootleg, but it's working for me at the moment. I usually average 3g per cake, per flush.    Congrats on getting those to finally pop.
    • Organix
      Thank you for the library of information & community! Questions regarding the Mush Zombie 60 qt monotub: During the "spawn to tub" (Section 3) 1)Do the holes need to be in place at this point? 2)Would it be ok to have the trash bag fully encapsulate the environment or does there need to be sufficient air exchange at this point? 3)If this is an issue during day 1 of 10 incubation, should one open the tub once a day to provide fresh air, or will it be ok for this 10 day period? The tub is in a 81*F bath (Cold House) & placed inside another tub to float on top. If all is good great, otherwise any suggestions would be greatly appreciated. Thank You Again!
    • Sonshyn
      I don’t think you’ll be able to post anything without me reading it in Bill’s voice . 
    • Mush Zombie
      Welcome to shroomology
×