Jump to content

Search the Community

Showing results for tags 'flowhood'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Administrative and Introduction Forums
    • Welcome to Shroomology!
    • Computer and Internet Safety
    • Shroomology's Sponsors Forum
  • Mushroom Growing Help
    • Getting Started Growing Mushrooms
    • General Mushroom Cultivation Questions & Answers
    • Mushroom Cultivation Archives
    • Frequently Asked Mushroom Question
    • Contamination
  • Mushroom Growing Techniques, Equipment and Tutorials
    • Mushroom Growing Tutorials
    • Pre-TEKS
    • Member Grow Logs
    • Experimental Mushroom Cultivation techniques
  • Mushroom and Species Information
    • Psychedelic Mushroom Information
    • Medicinal Mushroom Information
    • Wild Mushroom Hunting/Foraging
    • Mushroom Recipes
  • General Interests, and Off Topic Forums
    • General Psychedelia
    • Cannabis, Cacti, and other Cool Plants
    • The Upper Decker
    • Non-Sponsor Vendor Review
    • Hall of Fame

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 6 results

  1. Hi guys I'm having trouble finding just the hepa filters and the one I need. I'm seeing more cheaper versions on Amazon eBay etc. If you guys could help point me to reliable sites or something id appreciate it. Thanks alot
  2. How much static pressure should be created for laminar flow.. I had a flowhood built yesterday and I'm Leary of the design they choose to go with.. it barely blows out a match is this strong enough??
  3. Good morning, I've read and read and read, I've google-fu'ed, now it's time to make it so. Seems to be the next logical step to eliminate potential problems. So before I go ahead and pull a trigger I'd like to just throw what I've selected out there for my components. I'm aware of whats required and the fan may be a little bit much but with a controller we should be good. I'll be shopping between EBay and Amazon, whichever is cheapest on the parts I have already selected. I figure with some of you already in the flow hood world (Insider info) may be able to provide some valuable fee
  4. OpenBar

    Ajax Log

    Got this strain from a good fellow in the community, Now that I have the Flow hood, I was thinking good time to try out a new strain So far i just Made two Jars of Oats and Noc'ed them up yesterday. I think I will be going with Ztubs. But we will see as we go.
  5. Hello everyone! Just made my cheap flow hood Hope you enjoy. Lots of pics!! I had been looking online for a few weeks trying to find a cheap find. Found this fan on Craigslist for $40 Fan Specs. I wired it run on Lo After i got the Furnace Fan/blower I needed to make a box. I went with 20x20x20- 1/2" Plywood Next i got the fan on it to cut out the fan put the filter in just for fun. Next i sealed every crack i could find. Next i painted it all with some killz paint and primer sealer, I dont have any pics of the after paint
  6. Hello! Just looking for some opinions for filters for a flowhood. I read in an older post that the Merv12/13 electrostatic furnace filters are adequate enough for a flowhood as long as you replace them every few months. Adequate enough for even agar work? Also, do you think you would be able to put 2 HEPA filters side by side as long (as you made sure there was no air gaps or leakage between them)? They looked like this: Do you think that the gap might affect the laminar air flow or such a small gap wouldn't matter? On a side note I was looking at the pan cyan strains from m
×
×
  • Create New...